Wheel Installation Instructions

• Remove stock wheels
• If you have a threaded shaft, save nut to reuse later
• Leave front axle washers on axel
• Apply grease to shafts

Front axle:

• Slide front axle spacer onto shaft (reuse washer already on axle)
• Slide wheel onto shaft, mating center hexagon of wheel to spacer hexagon
• If axel is threaded, tighten nut to end of axel. If axel is a solid shaft, mate end cap hexagon to rim center and fasten set screw. 
• If there is a gap between the wheel and the nut or end cap, add washers to fill that gap as needed.

Rear axle:

• Slide rear drive adapter onto shaft; mate to drive
• Slide wheel onto shaft, mating center hexagon of wheel to adapter hexagon
• If axel is threaded, tighten nut to end of axel. If axel is a solid shaft, mate end cap hexagon to rim center and fasten set screw.
• If there is a gap between the wheel and the nut or end cap, add washers to fill that gap as needed.

    

Wheel Well Cover Installation Instructions

• Arrange template into corner as shown
• Trace around template
• Cut out shape
• Place Wheel Well Cover over cutout and secure with hardware